Richmond Fld in Gregory, Michigan has 1 runway. Runway 18/36 is 2,471 ft long and 100 ft wide. It has a turf surface. The field elevation is 921 ft MSL. No control tower is listed, so pilots should use standard non-towered procedures and monitor the CTAF if published in the current FAA Chart Supplement. No ILS runway ends are published here. That makes this a simple runway setup. The short turf strip still calls for careful performance planning. Check wind, density altitude and field condition before landing or departing.
Wind & favored runway
Favored end is picked from the current METAR wind at 69G.
Pattern entry · RWY 18
LEFT TRAFFICAll runways
Traffic pattern
Pattern altitude is not published. Use the standard 1,000 ft AGL pattern for light piston aircraft unless local procedures say otherwise. With no control tower, pilots self-announce and sequence themselves in the pattern. Runway 18/36 is the only runway, so pattern work centers on that north-south alignment. Check the current FAA Chart Supplement for any local pattern notes before flight.
Every end, one page
Each runway end has its own page with wind component, traffic pattern geometry and ILS for that specific direction.