INGALLS MUNI in Ingalls, Kansas has 1 runway. Runway 17/35 is 3,000 ft long and 75 ft wide. The surface is concrete. The field elevation is 2,814 ft MSL. No control tower is listed. No ILS runway ends are published for this field.
For pattern work, use the published pattern altitude if available. None is published here, so light piston pilots should plan around the standard 1,000 ft AGL pattern unless ATC or local procedures say otherwise. No runway-specific noise abatement notes are published. No LAHSO notes are published. This is a simple single-runway layout, so runway selection is straightforward. Check the current FAA Chart Supplement before flight for the latest airport remarks and any local changes.
Wind & favored runway
Favored end is picked from the current METAR wind at 30K.
Pattern entry · RWY 35
LEFT TRAFFICAll runways
Traffic pattern
Pattern altitude is not published for INGALLS MUNI. Light piston pilots should plan on a standard 1,000 ft AGL traffic pattern unless local procedures say otherwise. The field elevation is 2,814 ft MSL, so that puts a typical pattern near 3,814 ft MSL. No control tower is listed, so self-announcement and see-and-avoid discipline matter. No right-traffic exceptions are published. No runway-specific pattern notes are published. With only runway 17/35 available, pattern orientation is simple. Verify current airport remarks in the FAA Chart Supplement before you go.
Every end, one page
Each runway end has its own page with wind component, traffic pattern geometry and ILS for that specific direction.