ED-AIR at Oaktown, Indiana has 1 runway. Runway 18/36 is 4,572 ft long and 100 ft wide. The surface is asphalt. No ILS runway ends are published for this field. The airport has no control tower. Pattern altitude is not published, so use the standard 1,000 ft AGL pattern for light piston unless local procedures say otherwise. No LAHSO notes are published. No runway-specific noise abatement notes are published. Pilots should verify the current FAA Chart Supplement before flight. That is the best source for airport remarks and any local operating notes.
Wind & favored runway
Favored end is picked from the current METAR wind at I20.
Pattern entry · RWY 18
LEFT TRAFFICAll runways
Traffic pattern
Pattern altitude is not published. Use the standard 1,000 ft AGL pattern for light piston unless local procedures or ATC say otherwise. ED-AIR has no control tower, so pilots self-announce and self-sequence in the pattern. The field elevation is 426 ft MSL. That makes a standard pattern about 1,426 ft MSL. Runway 18/36 is the only runway, so pattern work will center on that alignment. No right-traffic exception is published. No special pattern notes are published in the facts.
Every end, one page
Each runway end has its own page with wind component, traffic pattern geometry and ILS for that specific direction.