Antlers Muni (80F) has 1 runway. Runway 18/36 is 4,001 ft long and 60 ft wide. The surface is asphalt. The field elevation is 576.7 ft MSL. No control tower is listed, so use standard non-towered procedures and monitor the CTAF as published in the current FAA Chart Supplement. No ILS runway ends are published for this field. No LAHSO notes are published. No noise abatement notes are published. The runway layout is simple. That makes preflight planning straightforward. You still need to check winds, density altitude and runway condition before you go.
Wind & favored runway
Favored end is picked from the current METAR wind at 80F.
Pattern entry · RWY 18
LEFT TRAFFICAll runways
Traffic pattern
Pattern altitude is not published. Use the standard 1,000 ft AGL for light piston aircraft unless the current FAA Chart Supplement or local procedures say otherwise. At a non-towered field like 80F, pilots self-announce and sequence themselves. Keep your pattern work tight and predictable. Verify the pattern direction before joining. Runway 18/36 is the only runway, so traffic flow will center on that single strip. No right-traffic exception is published. No special pattern note is published for this airport.
Every end, one page
Each runway end has its own page with wind component, traffic pattern geometry and ILS for that specific direction.